My Cart 0
Free Shipping on orders over $50

Brother HL-4150CDN Toner Cartridges

  • Black - Brother HL-4150CDN Toner.

    Black

    TN315BK
    Page Yield 6000

    $24.95

    Buy 3+: $23.70

  • Cyan - Brother HL-4150CDN Toner.

    Cyan

    TN315C
    Page Yield 6000

    $26.95

    Buy 3+: $25.60

  • Yellow - Brother HL-4150CDN Toner.
     

    Yellow

    TN315Y
    Page Yield 6,000

    $26.95

    Buy 3+: $25.60

  • Magenta - Brother HL-4150CDN Toner.

    Magenta

    TN315M
    Page Yield 6,000

    $26.95

    Buy 3+: $25.60

  • 4 Color Pack - Brother HL-4150CDN Toner.

    4 COLOR PACK

     
    $105.80 You save $9.85

    $95.95

Replacing Brother HL-4150CDN Toner Cartridges

Replacing the Brother HL 4150cdn toner cartridges is a very important part of printing successfully. A bad installation can cause problems that go from bad printing quality to damaging the toner cartridges or other printer parts.
Here are some easy steps that you can use to remove the used toner cartridges and install the new ones without damaging your printer or your toner.

Before start replacing the toner cartridges keep in mind the following safety recommendations:

CAUTION:

  • - Do not burn or throw used toner cartridges into open flames, as this may cause a fire
  • - If toner gets onto your hands or clothing, wash it off immediately with cold water. Do not use warm water as this may set the toner permanently, and you may not be able to remove the toner stains


Step 1: Turn the printer on and open the front cover by pressing the button shown in the picture.


Open Brother HL-4150cdn cover


Step 2: Hold the green handle of the drum unit and pull it out until it stops. Keep in mind that you shouldn't leave the drum unit out for too long. If drum unit is exposed to sunlight or room light for a long time, the unit may be damaged.


Remove Drum Unit


Step 3: Hold the used toner handle to push it toward the machine to unlock it. Then pull it out of the drum unit.


Pull out the toner cartridge


Step 4: Push to release the latches of the corona wire cover, and open the cover.


Open the corona wire


Step 5: Clean the corona wire by sliding the green tab from left to right and right to left several times.


Clean Corona Wire


Step 6: Make sure you have returned the tab to its initial position, then close the corona wire cover.


Close the corona wire


Step 7: Unpack the new toner cartridge and shake it from side to side to distribute the toner evenly.


Shake new cartridge


Step 8: Pull off the protective cover.


Pull off protective cover


Step 9: By holding the handle of the toner cartridge, slide it into the drum unit and ull it toward you until it clicks into place.


Insert toner


Step 10: Push the drum unit in and close the front cover.


Push the drum and close the cover