My Cart 0
Free Shipping on orders over $50

Konica Minolta BizHub C250 Toner Cartridges

  • Black - Konica Minolta Bizhub C250P Toner.

    Black

    TN-210K
    Page Yield 20000

    $34.95

    Buy 3+: $33.20

  • Cyan - Konica Minolta Bizhub C250P Toner.
     

    Cyan

    TN-210C
    Page Yield 12000

    $39.95

    Buy 3+: $37.95

  • Magenta - Konica Minolta Bizhub C250P Toner.
     

    Magenta

    TN-210M
    Page Yield 12000

    $39.95

    Buy 3+: $37.95

  • Yellow - Konica Minolta Bizhub C250P Toner.
     

    Yellow

    TN-210Y
    Page Yield 12000

    $39.95

    Buy 3+: $37.95

  • 4 Color Pack - Konica Minolta Bizhub C250 Toner.

    4 COLOR PACK

     
    $154.80 You save $18.85

    $135.95

Replacing Konica Minolta BizHub C250 Toner Cartridges

Cartridge Replacement for Konica Minolta Bizhub C250

Replacing the konica minolta bizhub C250 toner cartridges is a very important part of printing successfully. A bad installation can cause problems that go from bad printing quality to damaging the toner cartridges or other printer parts.

Here are some easy steps that you can use to remove the used toner cartridges and install the new ones without damaging your printer or your konica minolta bizhub c250 toner cartridges.

Before start replacing the bizhub c250 toner cartridges keep in mind the following safety recommendations:

CAUTION:

  • - Do not burn or throw used toner cartridges into open flames, as this may cause a fire
  • - If toner gets onto your hands or clothing, wash it off immediately with cold water. Do not use warm water as this may set the toner permanently, and you may not be able to remove the toner stains


Removing the used Konica Minolta Bizhub C250 toner cartridge


Open the Konica Bizhub c250 cover1. Open the cover board


Remove the Konica Bizhub c250 toner 2. Take the used bizhub c250 toner cartridge out of the printer


Installing the new Bizhub c250 toner cartridge

Shake the Konica Bizhub c250 toner3. Take the new konica minolta c250 toner cartridge out of the box and shake it firmly


Insert the new Konica Bizhub c250 toner4. Put the new cartridge into the printer


Close the cover Konica Bizhub c250 toner5. Close the cover board



Product Questions & Answers

Questions about Konica Minolta Bizhub C250 toner cartridges

Q: My printer is displaying error code C2557. How can I fix this?

A: You need to replace the imaging unit and the developer tank. After that your machine should start working again.

Q: I have a Konica Minolta Bizhub C250 and lately the prints and copies are very light that I’m not able to read them. I have replaced the toner cartridges but nothing has changed. What other parts should I change?

A: It seems to be a problems with the imaging unit, if you have replace the cartridges and the prints are still light, then you need to replace the opc drum.

Q: Every time I print something I get smudged copies. It prints a lite image from a previous copy which is not always the same. Any thoughts?

A: This is usually caused by the fuser section being left in envelope mode. To change it, open the door in the right side of the printer and look at the levers on the fuser unit, they shouldn’t be pointing to the envelope system, if they are, push them upwards.

Q: My bizhub c250 is showing that the transfer unit needs to be replaced; it means the kit including belt or just the unit?

A: It means that you will need to replace the whole unit

Q: I have blue lines appearing down one edge of the paper printouts. What can I do to solve this problem?

A: If the lines are only in blue, I think the problem might be the cyan imaging unit, you can release it from the machine and look at the drum to see if the lines are there (the drum is the greenish colored cylinder) , it should be clean with no lines of toner, fingerprints or scratches. Also try using your cleaning tools on the Imaging Units as well. This is the wand that is clipped inside the front door. There are also little blue knobs on the units you can pull out and push in a few times to clean wires inside the units. Don't touch the drum with your fingers; you can also try cleaning it with some alcohol and a q-tip. This should solve the problem; if not, you will have to change it

Q: Every time I print in color, there's a blue streak across the page, what can I do?

A: the problem might be cyan toner dust inside the printer; the best way to solve this is vacuuming the inside of the printer, especially around the imaging unit and toner cartridge