Replacing the Okidata C9650 toner cartridges

Replacing the Okidata C9650 toner cartridges is a very important part of printing successfully. A bad installation can cause problems that go from bad printing quality to damaging the toner cartridges or other printer parts.
Here are some easy steps that you can use to remove the used toner cartridges and install the new ones without damaging your printer or you Oki C9650 toner cartridges.

Before start replacing the Okidata C9650 toner cartridges keep in mind the following safety recommendations:

CAUTION:

• - Do not burn or throw used toner cartridges into open flames, as this may cause a fire
• - If toner gets onto your hands or clothing, wash it off immediately with cold water. Do not use warm water as this may set the toner permanently, and you may not be able to remove the toner stains

Removing the used Okidata C9650 toner cartridge

1. Turn handle to unlocking position.

2. Remove the used okidata c9650 toner cartridge.

Installing the new Oki C9650 toner cartridge

3. Place the used oki c9650 toner cartridge into the enclosed bag.

4. Take the new okidata c9650 toner cartridge from its packaging.

5. Shake the oki c9650 toner cartridge firmly.

6. Tear off the white stripe.

7. Install the new okidata c9650 toner cartridge into the developer.

8. Turn handle all the way to lock the oki c9650 toner in the developer.

9. Use cloth enclosed to clean LED lamp in the printer.

10. Close the cover.

 

 

 

 

 

Replacing the Okidata C9650 Image Drum

Replacing the Okidata C9650 image drum is a very important part of printing successfully. A bad installation can cause problems that go from bad printing quality to damaging the image drum units or other printer parts.
Here are some easy steps that you can use to remove the used drum units and install the new ones without damaging your printer or you Oki C9650 image drum.

Before start replacing the Okidata C9650 toner cartridges keep in mind the following safety recommendations:

CAUTION:

• - Do not burn or throw used toner cartridges into open flames, as this may cause a fire
• - If toner gets onto your hands or clothing, wash it off immediately with cold water. Do not use warm water as this may set the toner permanently, and you may not be able to remove the toner stains

Removing the used Okidata C9650 Image Drum

1. Switch off the printer and open the top cover.

CAUTION:

- Never expose the image drum to light for mor than 5 minutes and never expose the image drum to direct sunlight.

- Never touch the surface of the green drum inside the image drum unit.

2. Remove the used okidata c9650 toner cartridge as follows:

- Select the relevant image drum (C, Y, M or K). The toner cartridge sits on top of the image drum and has a locking lever at the front. move the toner locking lever anti-clockwise to unlock the toner cartridge from the image drum and deal its base so that toner does not escape.

- Lift the toner cartridge up at the front and then pull towards the front of the printer to release it from the image drum. Keep this toner cartridge safe as it will be returned to the printer once the new drum is installed.

- Lift the image drum from the printer whilst taking care not to spill any toner that may still be located inside.

NOTE: The printer has a special mechanism that allows all of the image drums to be lifted together to allow easier acces or clearing paper jams, please ensure that this mechanism is down before removing any of the image drums.

3. Remove the image drum.

Installing the new Oki C9650 Image Drum

4. Remove the new okidata c9650 drum from its bag and place it into the printer. The image drum has a special alignment pin to ensure that it is correctly installed this should be slid into the appropriate color coded slot.

5. A protection sheet has been included to ensure that the image drum surface is not damaged whilst in transit. To remove this sheet: release the tape at the top of the sheet and then pull the sheet firmly upwards.

6. Remove the remaining packaging (orange plastic).

7. Reinstall the toner cartridge by sliding forward into the top of the image drum and then pushing down at the front. Complete the toner cartridge installation by moving the locking lever clockwise.

8. Close the top cover.

Related offers: Okidata C9600 Toner | Okidata C9800 Toner | Okidata C9600 Drum | Okidata C9800 Drum | Okidata C9650 Drum