- Bundle up and save! Add 3+ single cartridges and get 5% off
Ricoh 1224C Toner Cartridges
One Year Warranty
All purchases are covered by a 1 year warranty against defects.
Free No Hassle Returns
Easy process and free shipping on returns.
96% of our orders are shipped the very same day.
10 years of experience supplying high quality toner cartridges.
Compatible Toner Cartridges
Compatible Toner Cartridges
Replacing the Ricoh Afico 1224c toner cartridges
Replacing the Ricoh Afico 1224c toner cartridges is a very important part of printing successfully. A bad installation can cause problems that go from bad printing quality to damaging the toner cartridges or other printer parts.
Here are some easy steps that you can use to remove the used toner cartridges and install the new ones without damaging your printer or you Ricoh Afico 1224c toner cartridges.
Before start replacing the toner cartridges keep in mind the following safety recommendations:
- - Do not burn or throw used toner cartridges into open flames, as this may cause a fire
- - If toner gets onto your hands or clothing, wash it off immediately with cold water. Do not use warm water as this may set the toner permanently, and you may not be able to remove the toner stains
Removing the used Ricoh Afico 1224c toner cartridge
1. Open the cover board of the Ricoh Aficio 1224c printer
2. Press the slide of the Ricoh Aficio 1224c toner cartridge, and push it back to the limit
3. Open it from outside and take out the used Ricoh Aficio 1224c toner cartridge
Installing the new Ricoh Aficio 1224c toner cartridge4. Take the new Ricoh Aficio 1224c toner cartridge out of the box and shake it firmly
5. Put the Ricoh Aficio 1224c toner cartridge into the printer
Questions about Ricoh 1224c Toner Cartridges
Question: I have a Ricoh Aficio 1224c printer and I’m getting bad quality prints and copies when there is more than one color. I’ve changed the Master Unit but it didn’t work.
Answer: This probably is not a problem with your ricoh 1224c toner cartridges. You should change the Bracket which is a part with a few gears, a clutch and a solenoid that controls the cleaning unit of the PCU-Unit.
Question: I had to move my printer the other day and moved it in my car laid on its side. Since then, the top of the page doesn’t print and the colors are not correct. It says that there is a problem with the finisher. What can I do?
Answer: First of all remember that you if you are going to move a printer from one place to another, you should never move it laid on its sides, you have to transport it always upright. There are a couple of things that probably happened. First of all try to take the developer units out and shake them from side to side to redistribute the toner evenly. If it doesn’t help, then the problems is bigger. Take a look at the inside of your printer to see if there is fuser oil spilled, this could ruin drive components and you may also have problems with the scanner. Another thing you can try is to replace the four development units (Black Cyan Magenta and Yellow).
I recommend that you call a technician before trying anything. It’s better to get your printer diagnosed by an expert.
Question: I’ve recently replaced the magenta ricoh 1224c toner and after printing a couple of pages, the printer shows “Change Magenta Toner” again. What to do in this case?
Answer: The toner you’ve bought might be defective. Sometimes the chip that comes with the cartridge doesn’t work properly and that’s why the printer doesn’t recognize it as a new full cartridge. Try installing a new one. If it doesn’t work call a technician.
Question: Hello, I got and error on my Ricoh Aficio 1224C, It says SC 570. There is any way I can fix it?
Answer: In this case your Ricoh Aficio 1224C has not fuser oil, you need to fill the tank located at the back side of your printer. If the tank is full, you should check the tubes, oil pump and oil sensor. When you have checked all these parts, please reboot the machine and the SC will be cleared.
Question: Hello, I have a Ricoh 1224c with problem code SC792, please help me.
Answer: The SC 792 Code means finisher error. You Ricoh Aficio 1224c does not recognize the finisher, it just recognize the relay unit. It could be caused by a defective connector, a defective cable or incorrect installation. You can try to turn off the printer and reset it. If the code does not disappear, try to press "clear mode" then enter 107 then press and hold "clear/stop" key until SP mode show up, then turn power off and back on.
|10/17/13||Imagetoner has been great. We receive the cartridges quickly and have only had a good experience with the company. It is quick and easy to order online.|
|10/10/13||I have more than 3 years working with the company and I am very happy with the service!|
|09/20/13||I've only used the magenta toner so far but the hp printer thought it was a genuine hp part.|
|09/12/13||Fast, priced right, and works everytime!|
|08/19/13||Very smooth transaction|
|08/01/13||The toner works great and saved me a fortune! Quite happy with my purchase. I'd love it if there was an obvious and simple way to ship back my old cartridges in the same box to have them recycled...|
- "Love this merchant, quick shipping, reasonable rates." Jeniffer Mazur
- "Your prices are fantastic and wonderful customer service (which is hard enough alone to find these days online, as you probably know). " Hunt 'n Gathers Specialist
- "Super fast shipping... great product as always! "
Prime Printing Corp
- "Awesome response time! I am going to need the toner next week - but I have the box already. "
- "All around excellent. Thanks. "
Kelly Dupre - Fun Instant T-Shirt LLC
- "I was delighted with my purchase and with imagetoner. I'll order again!!! "