Questions about Xerox Phaser 6110 Toner Cartridges

Q: I’m printing with my Xerox Phaser 6110 and all the black print are coming out lighter in the middle, almost unreadable. Color prints are good. I have tried installing a new black toner but it didn’t fix the problems.

A: This problem is not related with your black phaser 6110 toner cartridge, what you have to replace is the drum unit.

Q: My printer is showing an invalid black toner message while using a generic toner. What is the problem?

A: This problems is related with the chip inside the cartridge. You should try to replace it yourself or get a replacement. Some times the chip hasn’t been reset properly.

Q: I’ve just print about 500 pages with my Xerox Phaser 6110 and black print is very faint in some areas, it is also streaking. I have looked at the green roll inside of the cartridge and I don’t see any dirt. What can I do?

A: These errors in laser printers can be caused by different things. First of all you should check if the contrast is set to low and the toner cartridge level is low, empty or poorly distributed, these can be causing the faint printing. If adjusting the contrast doesn’t fix the error, try installing a new cartridge. Another thing that can be causing this issue is a weakened corona wire.

Q: I have a Xerox 6110 and it was printing ok until it suddenly stopped and started saying ‘deve home sensor error’. What does it mean?

A: This error means that there is a problem in the fuser unit. Try unplugging the power cord and plugging it back. If this doesn’t fix the problem, take the fuser unit out of the printer and check for any paper stuck on it. If there is no paper on the fuser you should replace the unit with a new one.